|
|
Post by roddyc130 on Oct 10, 2012 20:43:29 GMT 1
Does anybody know if this section where the floor joins the inner arch tub is meant to be welded together  ... i dont think it is, just seam sealer only ... Thanks   |
|
|
|
Post by Al Ramone on Oct 10, 2012 20:56:16 GMT 1
at least it's not too rusty ;D
|
|
|
|
Post by roddyc130 on Oct 10, 2012 21:57:35 GMT 1
at least it's not too rusty ;D You wanna see the other side Al ... lol ... the floor is being eaten away at !!  |
|
datman
Senior Member
Posts: 799
Location: West Sussex/Surrey
|
Post by datman on Oct 10, 2012 23:43:58 GMT 1
I would expect its a right angle with spot welds, then seam sealered?
|
|
|
|
Post by roddyc130 on Oct 11, 2012 8:47:27 GMT 1
Its a biggish gap and the metal looks clean enough, cant really see any signs of rotten weld tbh ...
|
|
paranoid
club Member
datsuns and old british cars wanted for breaking
Posts: 152
|
Post by paranoid on Oct 11, 2012 17:08:25 GMT 1
i welded mine
|
|
|
|
Post by RatDat on Oct 11, 2012 19:19:55 GMT 1
If it wasn't welded then it probably was never intended to be... it's not the kind of error you get in a Japanese factory. However, I doubt it'd hurt to weld it.
My 1200 pickup had lots of bits not welded but those WERE meant to be...it was a South African built Datsun and thus the build quality was just terrible.
|
|
|
|
Post by kaapstad on Jun 1, 2013 21:09:08 GMT 1
Is that under the rear seat? I can take a look on mine if you like?
|
|
